PDA

View Full Version : Zeagle wing question



cgvmer
08-19-2007, 20:22
I just obtained a very inexpensive unused zeagle 34lb lift wing. I want to use it with a non-zeagle backplate.

The only issue I have is those winglet side release buckles, what should I do with them as I prefer not to have them just floating around loose?

Any assistance would be appreciated.

NitroWill
08-19-2007, 20:50
Cut them off?

cgvmer
08-20-2007, 10:01
I'm not much into cutting my wings..... would prefer to purchase Quick disconnects and attach them to my BP

NitroWill
08-20-2007, 10:01
Sounds like you already knew the answer then :smiley36:

cgvmer
08-20-2007, 10:06
I was hoping someone who had this setup could let me know what they did.

ScottZeagle
08-20-2007, 10:09
Part # 519-BS01 Bladder Strap for Backplates. (You will need 2 of these)

The strap goes through the 2" webbing and allows you to clip the bladder wing.

Cost is about $7 each or around that...

NitroWill
08-20-2007, 10:09
For a quick (free) fix could always zip tie them off to the BP/BC to keep them from moving around

cgvmer
08-20-2007, 10:10
Scott Thank YOu!

ScottZeagle
08-21-2007, 08:49
No problem...that's why I am here...

;)

ScaredSilly
08-21-2007, 15:49
Not to take money away from Scott and Zeagle but you make these yourself for about $2.50. You need 1/2" two buckles (.75 each), two 1/2" sliders, (.25 each) and 18" of 1/2" flat webbing (.50). These can be assembled without any sewing. Visit a large outdoor shop like REI or IME.

ChillyWilly
02-29-2008, 10:52
Is this even worth the hassle. That is if you do have a sewing maching needles, gas to go find the stuff, etc.. O r you might spend the money on internet shipping.

If you make them tell us how much it cost you wih all included.

Good Luck,