inflator installation

webwidejosh · 10-13-2007, 01:30 PM

How do I install my Zeagle inflator to the BC? I notice a metal wire. Does that have to go around the pin in the inflator? I assume then its just a couple zip ties to hold the hose on, or would an actual hose clamp be better?

Scubastud16 · 10-13-2007, 03:53 PM

The wire goes around the pin on the inflator. Use zip ties to hold the corrugated hose to the inflator. Make sure they're tight.

GrtLks · 10-15-2007, 10:48 PM

Just to clarify, the pin should go through the loop in the wire. This is what opens the dump valve over your left shoulder when you pull on the corrugated hose.

webwidejosh · 10-17-2007, 12:54 PM

Quote:

Originally Posted by GrtLks

Just to clarify, the pin should go through the loop in the wire. This is what opens the dump valve over your left shoulder when you pull on the corrugated hose.

I was pretty darn sure of this, thanks so much for clarifying!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Inflator hose securing	torrey	DIY	19	10-29-2007 08:45 PM
BC inflator replacement question	Tableleg	BC's - Buoyancy Compensators - Stab Jackets	5	10-23-2007 10:32 AM
Inflator Hose on Brigade	lucidblue	Zeagle	17	08-07-2007 09:55 AM
Inflator hose compatibility?	torrey	How do I fix this?	11	08-04-2007 09:19 AM
WTB: Inflator (scubapro?)	torrey	WTB	0	08-03-2007 12:14 PM

		Scuba Forum - Scuba Diving Forums and Discussion Board > Scuba and Dive Gear Forum > DIY
inflator installation

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)