O-ring help needed

[diverdan_51]

Could someone tell me what size of O-ring is needed for the male fittings on the ends of a low pressure and high pressure regulator hose?

Also, if I lube these O-rings with silicone grease, will this contaminate my reg for nitrox use?

Thanks!

[No Misses]

low pressure - 3/8" - part # 2-011 (BN) or 2-211 (Viton)
high pressure - 7/16" - part# 2-012 (BN) or 2-212 (Viton)

These are static o-rings. They do not need to be lube'ed. Just use a little spit when securing fitting.

A little bit of silicone grease will not void recreational nitrox use (<40% O2). If you are using high percentages of O2, you must use an appropreate lube (Christo-lube).

I hope this helps.

[diverdan_51]

That helps a lot!

Thanks!!!!