Aeris Atmos Elite

[dludwig]

I am not able to connect my ATMOS to the transmitter on my first stage. Have checked all the obvious stuff. Batteries are OK. Thinking I new what I was doing (obviously I am an IDIOT ), I changed the codes but still no luck. Of course, positive this was the answer, I didn't write down the old code. (Told you I was an idiot.)

Any suggestions greatly appreciated !!!

thanks
Dennis

[TommyB]

the code is on the transmitter. should be 7 numbers or so.

[dludwig]

I'll try that. Thanks for the advice !!!

Dennis

[thor]

Where is the computer in relation to the transmitter? It needs to be slightly in front on the transmitter. (Not sure if you were trying to connect on land or water.)

[dludwig]

I have tried it both places. I must have goofed something up while I thought I was setting it up. Am going to email Tech Support. If that doesn't do it, will take it to the shop & pay them to figure it out. I really appreciate the tips!

[TxHockeyGuy]

My Aeris Elite is not very picky about where I have the wrist unit in relation to the first stage. The first stage does need to be on a tank and pressurized before it will transmit. Make certain you entered the serial number of the transmitter into the unit correctly, as previously stated it is on the outside of the first stage transmitter. You also stated you verified the battery is good, how do you know the transmitter battery is good? Did you remove it and test it with a volt meter?

[GordoninNM]

Agree with TxHockey...

I know that my VT3 (same computer maker, Oceanic/Aeris) does not transmit if unpressurized (saves batteries). If I try to connect and transmitter is not pressurized, the computer reads "transmitter unavailable".

I bet yours is similar

Gordo