Tool question, Mares MR12T - Scuba Forum

cbope · 09-01-2008, 05:24 AM

I have a Mares MR12T yoke first stage. I'm going to order a DIN conversion kit for it so I can utilize DIN-valved tanks that are common where I live. The yoke part of the reg is held in place with a single large nut, does anyone know what size this nut is? Obviously, it's probably metric.

And before anyone says "just measure it", well that's pretty much impossible with the regulator assembled unless you have a caliper, which I currently don't have.

I will need to get the proper sized wrench to remove this nut. Also, has anyone performed this conversion and can share their experience? I have an engineering background and am good with tools so I don't expect any problems, but it would be nice to know what is involved.

mitsuguy · 09-01-2008, 06:36 AM

There is a specific tool for it... Google scuba tools and you'll find a couple sites that sell regulator rebuild tools... That's on there...

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mares MR12T conversion from yoke to DIN	cbope	Regulators	3	08-25-2008 05:27 AM
Mares Icon BCD Question - Please Help	cyclone3565	How do I fix this?	4	02-23-2008 06:25 AM
Mares Airlab Question	Blindref757	Computers and Gauges	10	02-18-2008 12:03 PM
Mares Icon BCD Question	cyclone3565	Mares	1	01-27-2008 08:14 AM
Another Mares R2 Rebel and Viper Octo Question	james.earnhardt	Regulators	5	09-15-2007 03:49 PM

		Scuba Forum - Scuba Diving Forums and Discussion Board > Scuba and Dive Gear Forum > How do I fix this?
Tool question, Mares MR12T

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)